YASKAWA CPS-150F 控制电源单元 JZNC-XIU 01

控制电源单元 （CPS-150F）本机为 I/O 接触器单元 （JZNC-XIU 01） 和编程吊坠提供直流电源 （DC5V、24V）。它还配备了用于打开和关闭控制电源的输入功能。1. 拔下连接到控制电源单元的所有电缆。2. 松开连接控制电源单元和机架的四个上下螺钉。（每侧两个螺钉）。3. 从机架中拉出控制电源单元，拉杆固定在上下侧。4. 将新的控制电源单元插入机架的插槽中。5. 推动新的控制电源单元，直到其放置在与其他电路板相同的位置。6. 拧紧上下螺钉。7. 连接所有断开的电缆。系统控制电路板（JANCD-XCP01）该板执行控制整个系统，显示到编程吊坠，控制操作键，控制操作，计算插值，并与伺服控制电路板接口（与串行通信JANCD-XIF03或JANCD-XIF04）。该板具有用于RS-232C的PC卡接口和串行接口。JANCD-XMM 01 板（选件）可在展 CMOS 内存时安装。

Control power supply unit (CPS-150F) provides DC power (DC5V, 24V) for I/O contactor unit (JZNC-XIU 01) and programming pendant. It is also equipped with an input function for turning on and off the control power supply. 1. Unplug all cables connected to the control power supply unit. 2. Loosen the four upper and lower screws connecting the control power supply unit and the rack. (two screws on each side). 3. Pull out the control power supply unit from the rack, and fix the pull rods on the upper and lower sides. 4. Insert the new control power supply unit into the slot of the rack. 5. Push the new control power supply unit until it is placed in the same position as other circuit boards. 6. Tighten the upper and lower screws. 7. Connect all disconnected cables. System control circuit board (JANCD-XCP01) This board controls the whole system, displays to the programming pendant, controls operation keys, controls operation, calculates interpolation, and interfaces with servo control circuit board (with serial communication JANCD-XIF03 or JANCD-XIF04). This board has PC card interface and serial interface for RS-232C. Jan-XMM01 board (option) can be installed when developing CMOS memory.